YUKEN變量柱塞泵，油研泵技術數據
　　
　　suction piping and suction line filter should be located
　　lower than the pump position to prevent air in the suction
　　Install drain piping according to the chart and ensure that
　　3001) is recommended for this purpose
　　泵入口允許的吸入壓力為
　　-16+50 kPa（真空5 in.Hg，7 PSIG）。
　　對於吸入口的管道，請使用相同的管道
　　直徑與要使用的管道法蘭的直徑相同。
　　確保泵吸入口的高度pump generates excessive
　　Whenever there is fear of excessive load, please use rubber
　　7. Suction Piping
　　In case the pump is installed above the oil level, thecan otherwise lead
　　to breakdowns and shorten the life of the unit. Please
　　maintain the degree of contamination within NAS Grade
　　The suction port must be equipped with at least a 100 mm
　　(150 mesh) reservoir type filter and the return line must
　　have a line filter of under 10 mm.

YUKEN變量柱塞泵，油研泵技術數據
　　3. Mounting吸入壓力excessive load from the piping to the oil.
　　In case AR16 and AR22 pump, a 　　距水庫的油位不到米（3.3英尺）。
　　When installing the pump the filling
　　在AR16和AR22泵的情況下，配合的螺旋扭矩
　　為4050Nm（354443 IN.1bs。）。 不要